Netgear EAX80 Setup

To begin setting up your Netgear EAX80, make sure the extender is within range of your current WiFi router. After connecting it to a power source, watch for the LED lights to level out. Open a browser on your device, connect to the extender’s built-in WiFi network, and type www mywifiext net into the address bar. To configure the extender, select the network of your router and input the WiFi password as directed by the on-screen instructions. To optimize coverage, relocate the extender to your preferred spot within range when it is attached.

Netgear EAX80 Manual Guide

Plug the Netgear EAX80 in after positioning it within range of your router.

Await the solidification of the Power LED.

On a device, connect to the extender’s built-in WiFi network.

Go into mywifiext setup in a web browser.

To connect to the network of your router, follow the setup wizard’s instructions.
Either change the WiFi name (SSID) or leave it the same.

To get the best coverage, move the extender to the desired spot.

How do I Setup Netgear EAX80 Using WPS ?

Your WiFi router should be within range of the Netgear EAX80.

Wait for the Power LED to steady after plugging it into a power source.

Press the extender’s WPS button.

Click your WiFi router’s WPS key within two minutes.

Watch for the extender’s LED light to solidify, signifying a successful connection.

For connection to both bands, continue with steps 3–5 if your router supports dual bands.

After connecting, relocate the extender to a chosen spot inside the router’s coverage area.

To ensure ideal positioning, look for a steady connection LED.

Join the expanded WiFi network with your devices.

Firmware Update for Netgear EAX80 Wi-Fi Extender Setup

Link your device to the WiFi network of the Netgear EAX80 extender.
Go to mywifiext net setup in a web browser.
Enter the admin username and password for your extender to log in.
Go to Settings > Firmware Update from the dashboard.
To find out if there is a new firmware version available, click Check for Updates.
To find out if there is a new firmware version available, click Check for Updates.

Click Yes to download and install any available updates.
The extender will resume on its own after the firmware upgrade is finished.
After the update is complete, reconnect your devices to the WiFi network.

Note: If you need any assistance regarding your Netgear Nighthawk extender, get in touch with us via the chat button you see on the bottom right corner of this page.

How to Reset Netgear EAX80 setup ?

Find the reset button on the Netgear EAX80’s back or side.
For ten seconds, press and hold the reset button with a paperclip or pin.
When the Power LED begins to blink, let go of the button.
Await the LED lights stabilizing and the extender rebooting.
This will return the extension to its initial configuration.
Follow the original setup instructions to reconfigure the extender.

Netgear EAX80 Extender Login Steps

Link your device to the WiFi network of the Netgear EAX80 extender.
On the device you are linked to, launch a web browser.
In the address bar of the browser, type mywifiext setup login.
Enter the admin username and password for your extender to log in.
Follow the initial setup instructions if this is your first time logging in.
To make any necessary changes, go to the extender’s settings.